Making a little more progress! | Full Octane Garage

Making a little more progress!

October 4, 2012 Uncategorized

We made a little more progress on the assembly, had to send the cars off for a rebuild but they should only be gone for a week.

Please SUBSCRIBE AND FOLLOW US

Categories
Categories

Facebook

Archives
Archives

Recent Posts
- Pink Floyd Day 8
  
  Day number 8 was the magic day, the body has been separated from the chassis. My friends Ray and Carol along with my wife completed the Read More »
- Floyd Gets a New Power Plant and Suspension
  
  We finally made some driveability decisions so we decided to replace the old king pin front end with a new Jim Meyer Racing coil over with Read More »
- What’s New At The Full Octane Garage (12/2/18 Update)
  
  Full Octane Garage Project Updates (1933 Auburn is in paint) Read More »
- 1950 Five Window Update
  
  1950 Five Window Update picture Read More »
- Can a Spark Plug Break Glass?
  
  More fun from youetube! This is pretty crazy, who is going to try this first? Read More »
- You know you are a Car Guy if…episode 3
  
  3rd in the series “You know you are a Car Guy if…” Read More »
- 1 Year with the GMC Denali Sierra 1500, An Owner’s Perspective
  
  Well it has been 1 year and 36K miles since we bought the 2017 GMC Denali Sierra 1500. In this video, we will review the good, Read More »
- SEMA Day 2
  
  Read More »
- When you can not afford a real one
  
  We found this on Pintrest, for those who can not afford a real one 🙂 Read More »
- UnderCover Bed Cover for your GMC Truck
  
  The Full Octane Garage covers the unboxing, installation and operation of the UnderCover Bed Cover on a 2018 GMC 1500 Sierra. and …. Yes there are Read More »
- 2014 Corvette Delivery Day
  
  [nggallery id=96] Read More »
- Floyd – Week 4 Progress Update
  
  Week 4 has been wrapping up the bulk of the soda blasting. I finally got the door hinges and door strikers removed. I had to grind Read More »
- Project 63 – Interior Progress Update 5/13/13
  
  I am finally making good progress on the interior. I was able to get the Second Skin heat mat down and I got the whole rear compartment other Read More »
- Pink Floyd – Week 17 progress
  
  Week 17 has been busy. We started putting the frame back together. The new front suspension is now complete, the brake lines are plumbed and we are close Read More »
- Raptor Bed Liner used as undercoating on a 1950 Chevy Truck (Raptor by U-POL )
  
  This is a video we put together on using Raptor by U-POL as an undercoating and underside finish for both drivers and show cars. This application Read More »
- Full Octane Garage SHORT CUT featuring the 2016 Range Rover SVR
  
  Our SHORT CUT videos are brief “videos of opportunity” Today’s video features the new 2016 Range Rover SVR, Range Rover’s 550hp supercharged AWD SUV. Read More »
- I Paid The Porsche Tax!!! (Strange Car Story)
  
  You buy a Porsche 911 then to your surprise there is a Porsche Tax. This is a story of the pain of learning about the Porsche Read More »
- ICT Billet High Mount Narrow Bay AC Bracket Review (LS1/LS2/LS3 or Vortec 5.3) Part #551352-3
  
  We had bought an ICT Billet A/C Bracket part# 551494-3 and installed iton a 5.3 Vortec LS engine but unfortunately I did not measure where my Read More »
- DIY Porsche Cayenne Key FOB Battery Replacement
  
  A key FOB Battery cost HOW MUCH! DIY Porsche Cayenne Key FOB Battery Replacement. You will be shocked at how much mark up Batteries Plus is Read More »
- Pink Floyd – Week 16 progress
  
  Week 16 has brought some good progress. Most of the body is ready for paint. We completed painting the underside, engine bay, interior and trunk in Read More »
- Frame Work Continues
  
  We ran into another small snag this week. After we got the frame back form blasting I noticed a few areas where rust holes had begun. Read More »
- The DJI Phantom4 , a Visual Introduction
  
  As the Full Octane Garage continues our quest to improve our quality and content, we bring you, our wonderful viewers, a sample of content to come Read More »
- Atlanta Motor Speedway Autorama April 22 & 23
  
  The folks with the Atlanta Motor Speedway did an awesome multi-page article on Debby’s 31 Auburn in the Grease Magazine for the upcoming Motorama on Apr Read More »
- Chasing a McLaren 720S on the Dragon, 4K BTR 2018
  
  The Full Octane Garage took our classic Porsche 911 996 Cabriolet along with 11 exotic cars to drive the back roads of North Carolina with the Read More »
- The Welder & Plasma Cutter Arrived
  
  The Eastwood Welder & Plasma Cutter Arrived so we decided to video the un-boxing and set up. Read More »
- Engine and Trans mocked up in Project 50 Five Window
  
  We finally got back to work on the truck tonight, managed to get the LS engine and 4L60E transmission mocked up on the chassis. Tomorrow’s project Read More »
- Floyd – Week 11 Progress Update
  
  WOW, I have taken about 4 weeks off from the build project. We took a cruise to Alaska and came back with a cold that was Read More »
- Project 63 Paint Progress
  
  The paint is starting to look great! It is totally amazing at how bad you have to make the new lacquer paint look with the color sanding Read More »
- Pavers going down in dirty space (on a budget)
  
  Day 1 – For those of you who have been following us for a while know we have been using an area under a concrete porch Read More »
- Music City Dream Cars New Showroom Celebration!
  
  Full Octane Garage attended the new showroom Celebration for Music City Dream Cars! Located just off of Armory Drive along side Titan Motoring. What a great Read More »

May 2026

M T W T F S S

« Dec

1 2 3

4 5 6 7 8 9 10

11 12 13 14 15 16 17

18 19 20 21 22 23 24

25 26 27 28 29 30 31