Engine and Trans mocked up in Project 50 Five Window | Full Octane Garage

Engine and Trans mocked up in Project 50 Five Window

April 20, 2016 1950 Chevy Truck, Banner

We finally got back to work on the truck tonight, managed to get the LS engine and 4L60E transmission mocked up on the chassis. Tomorrow’s project is doing some measuring and adjusting on the LS engine plates, I think it is too far forward.

Please SUBSCRIBE AND FOLLOW US

Categories
Categories

Facebook

Archives
Archives

Recent Posts
- LOOK, it’s an engine! Pink Floyd now has an Engine and 5 speed
  
  Pink Floyd finally got an engine and 5 speed installed today. It will not belong before it gets a body! [nggallery id=56] Read More »
- Cool 62 Corvette Restomod
  
  This is a cool car done by my friend Darrin Woods! And the COOL garage is the Vintage Classic Garage in Franklin TN. [nggallery id=81] Read More »
- Project 63 week 3 – Tunnel Repair
  
  Well I am now in week 3 of Project 63 and there has been a lot going on. I started prepping for the Vintage Air install Read More »
- Project 63 got some color today!
  
  Project 63 got some color today! Pictures of Dennis doing the final shooting. Read More »
- Picked up a LS 5.3 and 4L60E trans today
  
  We picked up a complete LS 5.3 and 4L60E trans from a GMC truck today, I have plans to freshen it up and put in the 1950 Read More »
- Pink Floyd Week 23
  
  We made great progress during week 23 of the build. The A/C, radiator and almost all of the engine bay is complete. It seems like this Read More »
- Pink Floyd gets some BLING
  
  Pink Floyd started getting some BLING this week. The chrome has started arriving back from being redone so on it goes. We also finished the bulk Read More »
- Project 5 Window Chassis Update
  
  We made some nice progress on the chassis of the 1950 Chevy five window truck. We cleaned up and reinforced a bunch of the welds and Read More »
- Very cool Camper
  
  This is a very cool camper. Read More »
- DIY Porsche Cayenne Key FOB Battery Replacement
  
  A key FOB Battery cost HOW MUCH! DIY Porsche Cayenne Key FOB Battery Replacement. You will be shocked at how much mark up Batteries Plus is Read More »
- Pink Floyd Day 4
  
  It was a short night tonight. We were able to remove the parking brake, hood release and dash cluster. I also put some stuff on Craig Read More »
- Project LS-56 1956 C1 Corvette Restomod
  
  Read More »
- Project 63 – The new addition, a 1963 Split Window
  
  [nggallery id=75] Read More »
- Floyd – Week 4 Progress Update
  
  Week 4 has been wrapping up the bulk of the soda blasting. I finally got the door hinges and door strikers removed. I had to grind Read More »
- Hank Hill proves WD40 is the answer to all problems
  
  Read More »
- 1950 Chevy Truck Body Install
  
  We finally mounted the body on the frame of the 1950 Chevy Truck. Read More »
- Side Effects of Ethanol
  
  We know ethanol does some strange stuff to fuel systems but we did not think this is one of the expected side effects 🙂 Read More »
- Nashville Cars And Coffee 12-17-16
  
  This is a preview of a few of the cars that braved the wet roads and attended Nashville Cars And Coffee on 12-17-16. Read More »
- Project GMC LS-Z57 – Day 2 Tear Down – Mar 14, 2017
  
  We made a little more progress on the tear down tonight. So far no surprises, no rust and almost all of the bolts and screws are Read More »
- Floyd – Week 15 (Frame repair COMPLETE)
  
  As week 15 comes to a close we made great progress on the rust repair in the frame. There was a little more damage than I Read More »
- Removing and Storing the Freedom Roof Panels for the Jeep Wrangler Unlimited
  
  Today the Full Octane Garage will cover, with the help of our good friend Elvis from the Golden Drive and our fellow Jeep enthusiast, Zlatko, how Read More »
- Retrofit Modern Gauges in 1950 Chevy Truck
  
  We decided to Retrofit Modern Gauges in our 1950 Chevy Truck project but it turned out to be a bit more complicated that we had anticipated. Read More »
- Putting RUST 911 to the test!
  
  As part of our product testing we decided to put RUST 911 to the test and here is our Rust 911 review! Read More »
- Project 63 – 5/5 Progress Update
  
  We made some more progress this week The engine bay is mostly complete, got the master booster and brake cylinder installed, the air cleaner painted and Read More »
- The Welder & Plasma Cutter Arrived
  
  The Eastwood Welder & Plasma Cutter Arrived so we decided to video the un-boxing and set up. Read More »
- Very Cool Right Hand Drive 58 Corvette
  
  This is a very nicely done 58. With the custom right hand drive it looks like he must be in Australia or New Zealand. Read More »
- What’s New At The Full Octane Garage (12/2/18 Update)
  
  Full Octane Garage Project Updates (1933 Auburn is in paint) Read More »
- Pink Floyd Has A Body!
  
  The body and frame finally came back together as one today. The only thing left of Pink Floyd is the old hood hanging on the wall Read More »
- Black Vinyl Wrap for the new Corvette
  
  I decided to vinyl wrap the center section of the top and my first attempt was in a matt carbon fiber look. I tried it for a Read More »
- Pink Floyd has Glass
  
  Now that the windshield is installed it is really starting to look like a car again! [nggallery id=67] Read More »

June 2026

M T W T F S S

« Dec

1 2 3 4 5 6 7

8 9 10 11 12 13 14

15 16 17 18 19 20 21

22 23 24 25 26 27 28

29 30